Decorative Concrete in Mesquite TX - a good-looking finish over a solid base
Tired of a plain, worn or faded slab? We pour or refinish it with pattern and color you'll be glad to keep up.
- Fully licensed and insured.
- Free in-person estimates.
- We respond within 1 business day.
What goes into a decorative concrete patio, walk or driveway in Mesquite?
Decorative concrete puts stamped patterns, color, stains or an overlay on flatwork, the flat concrete of your driveway, patio and walks, so it looks like more than plain gray. In Mesquite it usually comes with digging out and packing a new base, setting steel, cutting joints and sealing, and most of the time goes into prep before the pour.
Most people call us when a slab looks plain, worn or faded, or when they're pouring something new and want it to match the house. The price moves with the size, the pattern, how many colors and borders you pick, and how much base work the ground needs. The schedule turns on the prep, the weather and any permit, because we don't book the truck until the ground and forms are ready. Before we set a date, we check with the city or county over your property on what the job needs and handle the permit when one's required. Your own figure comes in the written estimate.
How can you tell your concrete is ready for a new finish?
Color gone dull and chalky
The stamped or stained finish looks faded and water soaks in instead of sitting on top, which usually means the sealer has worn off in the sun. Left alone, foot traffic starts wearing into the color itself, and that's harder to bring back than a reseal.
Top flaking or turning dusty
Thin patches peel off or the surface rubs away as powder, which usually traces back to a pour in the midday heat or a finish worked too wet. It spreads every season, and a slab in that shape often needs repair or replacing before a decorative finish will hold.
Cracks wandering through the pattern
Cracks that cut across the stamp instead of following a joint line usually mean the joints went in late or the base under it settled. Water gets under through open cracks, so they tend to widen and the pieces start to tip.
Work that often goes with decorative concrete
Concrete retaining walls
If your patio or walk sits on a slope, a concrete retaining wall holds the ground back so the slab beside it doesn't slide or settle.
Concrete floor installation
Decorative finishes work indoors too, so a new concrete floor in a shop, sunroom or garage conversion can be stained or colored once it's poured and cured.
How we build decorative concrete
I start by walking the area with you and helping you weigh a fancier pattern or extra colors against your budget and the upkeep they'll need. Intricate patterns, several colors, borders and inlays can add curb appeal and resale value, but they cost more and need more frequent care to keep their look, so I'd rather you pick something you'll be glad to keep up. Then our crew digs out and packs the subgrade, the ground the slab sits on, sets the forms and the rebar, the steel that keeps cracks from spreading apart, and pours. We stamp, color or give it a broom finish, the light brushed texture that keeps it from getting slick, then cut control joints, grooves that give the slab a straight place to crack, and seal it once it's cured. If the budget's tight, I'd cut the pattern before I'd cut the base, because nobody sees the base on day one, but a fancy finish on a slab that sinks looks worse every year.
Decorative work often sits next to other concrete. If the patio steps down a slope, we can build the concrete retaining walls that hold the ground beside it, and if you want the same look inside, we handle concrete floor installation and finish the new floor to match.
New decorative pour
This suits a slab that's cracked, sunken or getting torn out anyway, because you get a fresh base and the pattern or color goes in while the concrete is placed. It costs more than refinishing, but it's the only way to fix what's under the slab.
Stain or overlay on your slab
This suits a slab that's still flat and sound but plain or worn, since a stain or a thin overlay changes the look without tearing anything out. It won't fix a slab that's moving, so I check that first.
Get a written estimate for your decorative concrete
Send the form and we'll reply within one business day to set up a free on-site visit, with no obligation. If you'd rather talk it through, call (214) 429-3296.
Call (214) 429-3296Why Mesquite homeowners call Frontier Mesquite Concrete Company for decorative concrete
The owner writes your estimate
I come out to look at the job and write the estimate myself, and our own crew does the digging, forming, pouring and finishing. You're dealing with the person who runs your pour, not a salesperson.
Ready before the truck shows
I spent years building the daily schedule for a busy concrete company before I started this one in Mesquite in 2023. We're known for having the ground, forms and steel ready before the truck pulls up, which matters on a stamped pour, since the pattern has to go in while the concrete is still workable.
Fully licensed and insured
We're fully licensed and insured, and our promise on every job is satisfaction guaranteed. You aren't left carrying the risk for a crew working on your property.
Base work for shrink-and-swell clay
Much of the ground from north of Dallas down toward San Antonio is Blackland Prairie clay that shrinks and swells hard as it dries out and gets wet, so we ask what grading and steel your site needs before any color goes down. We meet that same ground in Mesquite and the cities around it, from Garland to Forney.
On decorative concrete, the base you never see decides how long the finish you do see looks right. Set up a visit and I'll walk it with you.
What happens after you call us about decorative concrete in Mesquite?
Call or send a request
Call (214) 429-3296 or fill out the form with a few words about the area and the look you want. We set a time that works for you to meet on site.
I walk it and write it up
I measure, ask how you'll use the concrete and tell you plainly what I'd do and where I'd spend or save. The written estimate shows what's in the price and what isn't, so you know what you're paying for before you sign.
I set the date and prep
Once you say go, I set the date, line up materials and the permit side, and book the truck only when the prep is done. In Mesquite, any work that needs a permit also needs inspections, so I build those into the schedule instead of letting them hold up pour day.
Pour day and the cure
I run pour day, and we finish the surface while it's workable, then leave it to cure, the wait while it hardens enough to take weight. I'll tell you when it's ready to walk on and when it's ready to drive on, and we clean up before we leave.
Common questions
How much does decorative concrete cost in Mesquite, TX?
There's no one price, because decorative concrete is priced by the job, and tearing out an old slab, extra steel and sealing all add to it on top of the size and pattern. A Dallas cost guide also notes that high summer heat shortens the working window for pouring and sealing, which tightens contractor schedules and can affect price. Your own figure comes in the written estimate after I see the site.
What causes cracks in decorative concrete, and can reinforcement stop them?
Some cracking happens in almost any slab, because concrete shrinks as it dries and the ground under it moves, and reinforcement won't prevent it. National contractor guidance says the right amount of steel keeps random cracks from opening wide, so they show less in the pattern. I'll tell you how much reinforcement your slab gets before you sign.
How often does stamped concrete need resealing in the Dallas area?
A Dallas cost guide says to reseal stamped concrete every two to three years to protect it from sun and surface wear. Plan on it as regular upkeep, because the color holds up much better under fresh sealer than it does once the sealer wears through.
How do I hide control joints in a stamped concrete pattern?
You can sometimes hide them in the grout lines of the pattern, the lines that look like mortar, when those lines run roughly parallel. On a random pattern, national contractor guidance says the joints show more however they're formed, so if hidden joints matter to you, pick a pattern with straighter lines.
Who can get a permit through Mesquite's Citizen Self Service?
Citizen Self Service permits in Mesquite go only to licensed contractors and to owners who live in the home and homestead it through the Dallas Central Appraisal District. You can check this on the city's permit process page. Since we're licensed, we handle the permit when your job needs one, so you don't have to apply yourself.
Do I need city approval for a circular driveway in Mesquite?
Yes, a Mesquite ordinance says all requests for circular driveways at single-family detached homes need approval from the city's Manager of Traffic Engineering. It applies to driveways, not patios or walks, so if you want a circular decorative drive, check the current rule with the city and we'll plan the schedule around that approval.
Start planning your decorative concrete today
Have the project type, a rough size and a few photos of the area handy when you call (214) 429-3296 or send the form, and we can talk through the look before I come out.